Home

 BMW 740 Ninja 650 Other Stuff Contact Page FAQ & Legal

Enjoy, and remember ALWAYS work safe and I assume NO RESPONSIBILTY for your actions, mechanical abilities or anything that may occur during the nature of any repair.

The Site Has Been Revamped With Added Features, Please Update Your Bookmarks Accordingly.  I have now finalized writing all the redirects, so all the old pages will automatically redirect to the new pages.
 
         

Easy fix that gets rid of that dang “click” the seat belt would make.  Make sure you properly re-torque seat belt bolt, I used 29 foot lbs.

Parts:

Tools:

  • Flat Head Screwdriver

  • Pliers

  • Torque Wrench

  • 17mm Socket that fits torque wrench

  • Tools of choice or small flat blade screwdriver to separate parts

My total time was about a ½ hour.
Please Click On Any Picture Below To Enlarge That Picture.
Flat head screwdriver to remove front drivers plastic trim:
Remove any clips that remain with some type of pliers:
Start by removing the lower B pillar panel, grab the bottom and pull:
Now the top trim, again grab the bottom and pull:
This is the back of bottom panel.  The top arrows represent the hooks, the bottom are clips:
This is the back of the top panel.  The top is a hook, the bottom are clips:
Now remove the bolt that holds the seatbelt, it a 17mm:
This is the piece we are replacing:
Old left and New right, big difference:
Tool of choice to remove old ring:
Rings and clip that holds the things in place:
New one installed:
Front of clip:
TOP



All Donations Help Defer The Cost Of This Site, And In Most Cases This Site Has Or Will Save You Some Money.
Copyright © Magnum / Magnum1.com 2003-2014.

Disclaimer: Not for distribution, redistribution, sale, re-sale or otherwise without my written consent.  You do have consent to link back to any page on this site that may assist individuals.  This information is presented with no liability or guarantee expressed or implied, work at your own risk.