I wanted a place to
mount my Amp, Capacitor, DVD Changer and anything else I may come
across in the future. So I built a custom wood shelf to mount to
the top of the trunk shelf. It took a little bit to get the
design layout and I actually started with a piece of cardboard to get
all the angles cut right and from there I traced it on a piece of wood
and went at it.
I think it turn
out great and has served its purposed very well!
Basically I used:
- A large piece
of wood
- A Bottle of
Spray Adhesive
- A few nuts,
bolts and washers
- Some screws
- A drill and
drill bits
- A 1 1/2" hole
bit
- A saw [jigsaw
is best because of the angles]
- Various
sockets 6mm, 8mm and 10mm
- Ratchet
- Dremel
- Staple Gun
Basically the whole
rear interior of the vehicle needs to come out, this includes the rear
seat, speaker cover, c pillars and rear window shade. It was long
project, but I am extremely happy with the results.
Below please find
the full install details.
Enjoy, and remember ALWAYS work safe and I assume NO
RESPONSIBILITY for your actions, mechanical abilities or
anything that may occur during the nature of the repairs.
Disclaimer: Not for
distribution, redistribution, sale, re-sale or otherwise without my
written consent. This information is presented with no liability or
guarantee expressed or implied, work at your own risk.
Copyright © Magnum / Magnum1.com 2003-2008. |